Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
- Transmission line
   + Coupling
   + Driveshafts
   - Power shafts
      Removal and installation of a rotary fist, replacement of a spherical support
      Removal and installation of a flange of a forward power shaft and two-row radial-stop ball bearing of a forward nave
      Removal and installation of back stupichny assembly, replacement of a spherical support
      Removal and installation of a flange of a back power shaft and two-row radial-stop ball bearing of a back nave
      Removal and installation of power shafts
      Replacement of boots of hinged assemblies of power shafts
   + Transfer case and differentials
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal and installation of a flange of a back power shaft and two-row radial-stop ball bearing of a back nave

Details of installation of a flange of a back power shaft and two-row radial-stop stupichny bearing

8 — the Stupichny bearing
9 — the Lock ring
37 — the Power shaft

111 — the Brake support
112b — the Brake disk
112s — the Brake board


 PERFORMANCE ORDER

  1. Details of installation of a flange of a back power shaft and the radial-stop stupichny bearing are shown on an illustration to which all references which are found in the text belong.
  2. Remove a back power shaft (37) (see the Section Removal and installation of power shafts).
  3. Without disconnecting a hose, remove a back brake support (111) (see the Head Tormoznaya and auxiliary systems).
  4. Remove a brake disk (112b) (see the Head Tormoznaya and auxiliary systems).
  5. Take off boots of the parking brake (see the Head Tormoznaya and auxiliary systems).
  6. By means of a hydraulic extractor remove a flange of a back power shaft (10) from the stupichny assembly remaining on the car.

If the effort in 40 Nanometers for removal of a shaft appears insufficiently, it is necessary to remove stupichny assembly and to repeat the procedure in stationary conditions.

  1. By means of special nippers remove a lock ring (9).
  2. In case of need remove a brake board (112s).
  3. By means of a special stripper to a vypressuyta from stupichny assembly the two-row radial-stop bearing (8).
  4. Vypressuyte an internal holder of the bearing from a flange of a power shaft.
  5. Estimate sizes of cross and radial side plays of a flange (10), in case of need make replacement.
  6. Installation is made upside-down.