Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
+ Brake and auxiliary systems
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   + Steering
   - Suspension bracket geometry
      Check of geometrical parameters of the unit of bridges
      Check and adjustment of height of road gleams
      The angles of installation of wheels of the car - the general information
      Check and adjustment of disorder and vybeg
      Check and adjustment of convergence
      Check of size of a divergence of forward wheels in turn
+ Body
+ Onboard electric equipment


Check and adjustment of height of road gleams

Check and adjustment of height of road gleams of axes

086 — the inclination Measuring instrument

086a — the Sensor


Check and adjustment of height of road gleams of axes

Check and adjustment of height of road gleams of axes, - the left back point of measurement

Check and adjustment of height of road gleams of axes, - the left forward point of measurement

Check and adjustment of height of road gleams of axes

4 — the Right lower cross lever

4a — the Screw


 PERFORMANCE ORDER

  1. The corresponding illustrative material is presented on illustrations to which all references which are found in the text belong.
  2. Estimate degree of wear of protectors, replace defective tires.
  3. Check correctness of pressure of a rating of tires, in case of need make the corresponding adjustment.
  4. Height of a road gleam of axes of the car is determined by a tilt angle of the lower levers of the corresponding suspension bracket.
  5. Put a magnetic measuring element (086b) in deepening in the lower lever of a suspension bracket (4).

On the models equipped with xenon headlights turn out a bolt (4a) so that it ceased to act from the lever (4). The plate of a measuring element (086b) has to settle down a flute at an angle 90 ° to the direction of the movement.

  1. Write down results of measurements for each lever of both suspension brackets.
  2. Adjustment of height of a road gleam of a forward axis is made by correction of landing of support of the torsion springs.
  3. Correction of a gleam of a back axis is carried out by means of replacement of screw springs of rack-mount assemblies.