|
|
Mercedes M-Class W163since 1997 releaseRepair and operation of the car |
|
|
Mercedes W163 + Mercedes-Benz cars of a class M (W163) + Governing bodies and methods of safe operation + Current leaving and service + Engine + Cooling systems, heating and air conditioner + A power supply system and production of the fulfilled gases + Systems of electric equipment of the engine + Manual box of gear shifting + Automatic transmission + Transmission line + Brake and auxiliary systems - Suspension bracket and steering + Forward suspension bracket + Back suspension bracket + Steering - Suspension bracket geometry Check of geometrical parameters of the unit of bridges Check and adjustment of height of road gleams The angles of installation of wheels of the car - the general information Check and adjustment of disorder and vybeg Check and adjustment of convergence Check of size of a divergence of forward wheels in turn + Body + Onboard electric equipment |
The angles of installation of wheels of the car - the general information The angles of installation of wheels considerably influence stability of the car, wear of tires and fuel consumption. Nominal rates of corners are specified in Specifications. Disorder is called the wheel plane tilt angle concerning a vertical. If wheels are inclined by the upper edges outside, disorder is called positive and vice versa. The size of disorder is measured in degrees. Correctness of adjustment of disorder determines the size and the provision of a spot of contact of protectors with a paving and allows to compensate the changes in suspension bracket geometry happening during commission of turns and at the movement of the car on an uneven paving. Convergence (convergence) is called data size to each other of forward edges of wheels of the car. Such violation of parallelism of installation of wheels allows to minimize wear of a protector due to prevention of a skid at commission of turns. At zero convergence the distance between forward edges of wheels is equal to distance between their rear edges. Normal convergence usually does not exceed inch shares (1 inch = 2.54 cm). Violation of adjustment of convergence leads to acceleration of wear of protectors of tires due to slipping them on a paving. Vybegom is called a corner of a longitudinal inclination шкворня / axes of turn of a wheel, i.e., a corner of a deviation of this axis from a vertical in the rim plane. If the axis the turn/pivot axle is inclined back, выбег is called positive, on the contrary.
Divergence of the operated wheels in turn is called the difference between angles of rotation of internal and external wheels when the first is turned under the set corner. Conditions of check of angles of installation of wheels Check of angles of installation of the car demands existence specially equipped the platform/elevator. Before check it is necessary to make sure of performance of the following conditions:
|
|