Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
+ Brake and auxiliary systems
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Filling and "pumping" of the steering pump
      Check of a pressure of the steering pump
      Replacement of a collar of fastening of a hose of a path of cooling of GUR liquid
      Assessment of a condition of hinges of steering drafts and boots of a case of rack transfer
      Removal and installation of the steering pump
      Replacement of boots of a case of the steering mechanism
      Removal and installation of tips of steering draft
      Removal installation of entrance knot of the steering mechanism
      Removal and installation of the steering mechanism
      Dismantling of the mechanical regulator of a steering column
      Removal and installation of a steering wheel and spiral contact drum of a steering column
      Removal and installation of the cylinder of the lock of ignition
      Removal and installation of the lock of blocking of a steering column
      Removal and installation and shirts of a steering column
   + Suspension bracket geometry
+ Body
+ Onboard electric equipment


Steering

Filling and "pumping" of the steering pump

 PERFORMANCE ORDER

Activation of the steering pump filled with air is inadmissible by no means!

  1. Illustrative material according to procedures of filling and pumping of the pump GUR is presented on an illustration to which all references which are found in the text belong.

    Removal of a cover from the steering pump

  2. Uncover and fill the tank of the steering pump (30a) to level about 10 mm below the upper edge, - in case of need take aside an air sleeve (47).
  3. For 2-3 minutes start the engine and several times turn a steering wheel from an emphasis against the stop, - air from a hydraulic path of the steering amplifier has to be removed automatically.
  4. Check liquid level in the GUR tank, in case of need make the corresponding adjustment (see the Head of the Power supply system and production of the fulfilled gases).
  5. Make sure of lack of signs of development of leak of hydraulic liquid of system of hydrostrengthening of a wheel.
  6. Establish into place a cover if shifted, - return into place an air sleeve (47)