Mercedes M-Class W163

since 1997 release

Repair and operation of the car

Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
+ Brake and auxiliary systems
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Filling and "pumping" of the steering pump
      Check of a pressure of the steering pump
      Replacement of a collar of fastening of a hose of a path of cooling of GUR liquid
      Assessment of a condition of hinges of steering drafts and boots of a case of rack transfer
      Removal and installation of the steering pump
      Replacement of boots of a case of the steering mechanism
      Removal and installation of tips of steering draft
      Removal installation of entrance knot of the steering mechanism
      Removal and installation of the steering mechanism
      Dismantling of the mechanical regulator of a steering column
      Removal and installation of a steering wheel and spiral contact drum of a steering column
      Removal and installation of the cylinder of the lock of ignition
      Removal and installation of the lock of blocking of a steering column
      Removal and installation and shirts of a steering column
   + Suspension bracket geometry
+ Body
+ Onboard electric equipment

Removal and installation of the cylinder of the lock of ignition

When jamming a key in the cylinder of the lock sprinkle the last special spray, - if greasing does not help, the cylinder should be replaced.

Details of installation of the cylinder of the lock of ignition are shown on illustrations to which all references which are found in the text belong.

Details of installation of the cylinder of the lock of ignition

Removal

PERFORMANCE ORDER

By means of a suitable hook remove the coil of the transponder (L11) from the lock cylinder.

Turn a key in the lock in situation 1, then it is a little more (before click).

Having turned a cover (36b) on 90 ° counterclockwise, remove the cylinder of the lock (36).

Installation

PERFORMANCE ORDER

Grease the cylinder (36) with special lubricant and put it in a cover (36b).

Pass a key through a cover (36b) and against the stop enter it into the lock cylinder, - cams have to clean up completely.

Fill the cylinder (36) in castle assembly, - track that uvulas (shooter) of the cylinder (36) were combined with deepenings in the lock (shooter).

By means of a mandrel (011) develop a cover (36b) on 90 ° clockwise before click of a clamp.

Turn a key in the cylinder in situation 0 and remove a mandrel (011).

Put the coil of the transponder (L11) on the cylinder (36).