Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
+ Brake and auxiliary systems
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Filling and "pumping" of the steering pump
      Check of a pressure of the steering pump
      Replacement of a collar of fastening of a hose of a path of cooling of GUR liquid
      Assessment of a condition of hinges of steering drafts and boots of a case of rack transfer
      Removal and installation of the steering pump
      Replacement of boots of a case of the steering mechanism
      Removal and installation of tips of steering draft
      Removal installation of entrance knot of the steering mechanism
      Removal and installation of the steering mechanism
      Dismantling of the mechanical regulator of a steering column
      Removal and installation of a steering wheel and spiral contact drum of a steering column
      Removal and installation of the cylinder of the lock of ignition
      Removal and installation of the lock of blocking of a steering column
      Removal and installation and shirts of a steering column
   + Suspension bracket geometry
+ Body
+ Onboard electric equipment


Check of a pressure of the steering pump

Verification of the pressure head characteristic of the steering pump

Verification of the pressure head characteristic of the steering pump

Verification of the pressure head characteristic of the steering pump

Verification of the pressure head characteristic of the steering pump


 PERFORMANCE ORDER

  1. Illustrative material according to procedures of verification of the pressure head characteristic of the pump GUR is presented on illustrations to which all references which are found in the text belong.
  2. Open a cover (30g) and pump out hydraulic liquid from the tank of the steering pump.
  3. Disconnect from the pump a pressure head broad hose (30i) and connect to the last a transitional nozzle (038a).
  4. Connect a transitional nozzle to the union of the pump (038b).
  5. Connect the manometer (039) between transitional nozzles (038a and 038b).
  6. Fill the GUR tank with fresh liquid to the required level.
  7. Start the engine and lift its turns till 1000 a minute.
  8. Block the throttle crane (039a) and read out the indication of the maximum working pressure of the pump GUR from the manometer, - try to consider the indication as soon as possible in order to avoid risk of an overheat of oil. Compare result of measurement to nominal rate (see Specifications).
  9. Kill the engine and pump out oil from the GUR tank.
  10. Remove the manometer and restore initial connection of hydraulic lines, - do not forget to replace a sealing ring of the nipple socket of a broad hose (30i).
  11. Fill in in the tank the required amount of fresh liquid (see the Head of the Power supply system and production of the fulfilled gases).
  12. In conclusion visually check a hydraulic path of GUR for existence of signs of development of leaks.