Mercedes M-Class W163

since 1997 release

Repair and operation of the car


Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
+ Brake and auxiliary systems
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Filling and "pumping" of the steering pump
      Check of a pressure of the steering pump
      Replacement of a collar of fastening of a hose of a path of cooling of GUR liquid
      Assessment of a condition of hinges of steering drafts and boots of a case of rack transfer
      Removal and installation of the steering pump
      Replacement of boots of a case of the steering mechanism
      Removal and installation of tips of steering draft
      Removal installation of entrance knot of the steering mechanism
      Removal and installation of the steering mechanism
      Dismantling of the mechanical regulator of a steering column
      Removal and installation of a steering wheel and spiral contact drum of a steering column
      Removal and installation of the cylinder of the lock of ignition
      Removal and installation of the lock of blocking of a steering column
      Removal and installation and shirts of a steering column
   + Suspension bracket geometry
+ Body
+ Onboard electric equipment

Replacement of a collar of fastening of a hose of a path of cooling of GUR liquid

Replacement of a collar of fastening of a hose of a path of cooling of GUR liquid to a radiator


 PERFORMANCE ORDER

  1. Weakening of a collar of fastening of a hose of a cooling path of GUR to a radiator leads to development of leak of hydraulic liquid.
  2. Kill the engine and take a key from the ignition lock.
  3. Open a cowl, open and remove from a hose (2) a fixing collar (1).
  4. Open a new collar (3) and put on it a hose (2).
  5. Having correctly placed a collar on the end of a hose tense on the union, strongly tighten it.
  6. Check GUR liquid level, in case of need make the corresponding adjustment (see the Head of the Power supply system and production of the fulfilled gases).
  7. Start the engine and make sure of lack of signs of development of leaks through a hose.
  8. Close a cowl.