Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
+ Brake and auxiliary systems
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Filling and "pumping" of the steering pump
      Check of a pressure of the steering pump
      Replacement of a collar of fastening of a hose of a path of cooling of GUR liquid
      Assessment of a condition of hinges of steering drafts and boots of a case of rack transfer
      Removal and installation of the steering pump
      Replacement of boots of a case of the steering mechanism
      Removal and installation of tips of steering draft
      Removal installation of entrance knot of the steering mechanism
      Removal and installation of the steering mechanism
      Dismantling of the mechanical regulator of a steering column
      Removal and installation of a steering wheel and spiral contact drum of a steering column
      Removal and installation of the cylinder of the lock of ignition
      Removal and installation of the lock of blocking of a steering column
      Removal and installation and shirts of a steering column
   + Suspension bracket geometry
+ Body
+ Onboard electric equipment


Removal installation of entrance knot of the steering mechanism

Details of installation of entrance knot (25) of the steering mechanism (23)


 PERFORMANCE ORDER

  1. Details of installation of entrance knot of the steering mechanism are shown on сопр. an illustration to which all references which are found in the text belong.
  2. Bring forward wheels into rectilinear situation and record a steering wheel by means of special adaptation.
  3. At the corresponding complete set remove the right thermofilter (105d) of system of production of the fulfilled gases.
  4. Give a nut (25e) and a bolt of fastening of entrance knot (25) of the steering mechanism.
  5. Release a nut (25d) of the bolt connection of an entrance shaft of knot (25) with the lower shaft of a steering column (80a).
  6. Having accurately pulled up, release entrance knot (25) from assembly of the operating valve of the steering mechanism, - at all do not use force, - in case of need slightly unclench the lock the screw-driver!
  7. At the corresponding complete set remove a casing (25f) of entrance knot.
  8. Installation is made upside-down, - at installation of entrance knot the lath has to be in neutral (central) situation.