Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
+ Brake and auxiliary systems
- Suspension bracket and steering
+ Forward suspension bracket
- Back suspension bracket
Removal and installation of assembly of the back bridge
Removal, dismantling and installation of back racks
Removal and installation of the torsion bar
Removal and installation of the lower cross lever
Removal and installation of the top cross lever
Remove also installation of a longitudinal extension
+ Steering
+ Suspension bracket geometry
+ Body
+ Onboard electric equipment
|
Removal and installation of the top cross lever
Details of installation of the top cross lever of a back suspension bracket
|
|
|
|
In total самоконтрящиеся bolts and nuts are subject to replacement without fail! |
- Details of installation of the lower cross lever of a back suspension bracket are shown on an illustration to which all references which are found in the text belong.
- Remove back wheels, remove the spare wheel (except models with fastening of the last on the holder behind a door of a back and models 163.174). At the corresponding complete set remove the external holder of a spare wheel.
- On models 163.174 (ML 55 AMG) remove loker of protection of wheel arches.
- Remove the wheel sensor (L6/3, - in case of the left lever).
- Disconnect rack-mount assembly (6j) from a side beam of a suspension bracket (see the Section Removal, dismantling and installation of back racks).
- Squeeze out the top spherical support (91a) of stupichny assembly.
- Disconnect from a stretcher the lower cross lever (see the Section Removal, dismantling and installation of back racks).
- Give fixing nuts, previously having marked adjusting provisions (shooters), take axial bolts (91b) and separate the top lever (91) from a frame beam.
- Check a condition of rubber axial plugs and a spherical support, in case of need make replacement (see the Sections Removal and installation of the lower cross lever, replacement of the forward axial plug and Check of a condition of spherical support of a rotary fist).
- Installation is made upside-down, - at installation of levers assembly of the bridge has to hold strictly horizontal position. Track correctness of combination of the landing tags (arrow) put in the course of dismantle.
|
|
|
|