- Details of installation of boots of the parking brake are shown on an illustration to which all references which are found in the text belong.
- Remove brake disks of back wheels (see the Section Removal and installation of a brake disk).
- By means of special adaptation (041) disconnect coupling springs (111).
- Remove anchor springs (107) and fingers (106).
- Take off brake boots (103) from a flange of a back power shaft (68).
|
|
If boots (103) burned, it is necessary to make their replacement in a set with coupling springs (111 and 112) and anchor elements (106 and 107). |
- Disconnect a coupling spring (112) and remove a razzhimny level (109).
- Installation is made upside-down, - the persistent and sliding surfaces of a razzhimny level (109) before installation should be greased with jellied molibdensoderzhashchy lubricant, grease with the same lubricant a carving of a persistent element (104), and also a cylindrical part of an adjusting castor (c). At installation actually of boots release the adjusting mechanism and track that a regulator castor (c) it appeared in detail down, track correctness of connection of coupling (111 and 112) and anchor (107) springs.
- Make adjustment of the parking brake (see the Section Adjustment of the Drive of the Parking Brake) and unload the automatic regulator.
|
|