|
Removal and installation of a pedal of raising of the parking brake
Details of installation of a pedal of raising of the parking brake
|
|
|
|
In total самоконтрящиеся bolts and nuts are subject to replacement without fail! |
- Details of installation of a pedal of raising of the parking brake are shown on an illustration to which all references which are found in the text belong.
- Make a preliminary tightness of the regulator of a weak point (the compensation lever) of a driving cable.
- Uncover (71) pedal assembly.
- Remove the sensor switch of raising of the parking brake (S12).
- Disconnect a cable (85) from a tension earring on a pedal (75) and release it from a clamp by means of special adaptation (043), - try not to drop a rubber ring (85s).
- Weaken a bolt (72) and remove pedal assembly (75).
|
|
Do not release bolts with TORX heads from the back party of assembly! |
- Remove an arm (77a) and disconnect a cable of an otpuskaniye of the parking brake (79) from the operating lever (77), further disconnect a cable from pedal assembly (75) by means of adaptation (010) and remove it.
- Installation is made upside-down. In conclusion unload the weak point regulator (the compensation lever) and make adjustment of the drive of the parking brake (see the Section Adjustment of the Drive of the Parking Brake).
|
|
|