- Details of installation of the tank of the washing liquid are shown on illustrations to which all references which are found in the text belong.
- Remove the top cross beam of a frame (see the Section Removal and installation of the top forward cross beam of a frame).
- Disconnect an electrical wiring and hoses from pumps (5) of supply of the washing liquid and, - at the corresponding complete set, - from the liquid level sensor.
- Release a hose (3) of the refrigerator highway K/V from a clamp (4).
- On models 163.128 (ML 400 CDI) uncover also intermediate clamps of fastening of hoses to the assembly block of safety locks/relay.
- Release the heat exchanger of a cooler (10) from the lower landing plugs.
- By means of the assistant raise a cooler (10), turn out a bolt (2), release the tank of the washing liquid (1) from landing plugs (6), take away it inside and, having pulled up, take from a motive compartment.
- Installation is made upside-down, - track completeness of landing of the tank (1) in plugs (6) and reliability of a zashchelkivaniye of a side clamp.
|
|