- Details of installation of the transfer case are shown on an illustration to which all references which are found in the text belong.
- Remove panels of finishing of a motive compartment.
- Remove system of production of the fulfilled gases from basic arms (9 and 10).
- Turn out bolts (14), disconnect from the transfer case and tie up the back driveshaft (13) to frame elements, - try not to damage hinged assembly and the central bearing.
- Turn out bolts (12), disconnect from the transfer case and tie up the forward driveshaft (11) to frame elements, - try not to damage hinged assembly.
- Disconnect an electrical wiring (3) from the servomotor.
- Prop up transmission assembly (1) and remove a cross beam with a back support of a suspension bracket of the power unit (5).
- Prop up the transfer case (2) a jack.
- Turn out bolts (4), separate the transfer case from transmission and remove it, having given on a jack back.
- Installation is made upside-down.
- In conclusion make sure that the level of the oil which is filled in in a box reaches the lower cut of a jellied/control opening.
|
|