Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
- Transmission line
   + Coupling
   + Driveshafts
   + Power shafts
   - Transfer case and differentials
      Removal and installation of the module of management of the transfer case
      Removal and installation of the transfer case
      Replacement of an epiploon of an entrance shaft of the transfer case
      Replacement of an epiploon of an output flange of the back driveshaft
      Replacement of an epiploon of a forward output shaft
      Removal and installation of the servomotor of switching of the modes of the transfer case
      Removal and installation of the chain drive of the transfer case
      Removal and installation of a forward output shaft of the transfer case
      Removal and installation of assembly of a planetary reducer of interaxal differential of the transfer case
      Removal and installation of assembly of bearing assembly of the transfer case
      Removal and installation of the oil pump of the transfer case
      Removal and installation of the mechanism of switching of the transfer case
      Removal and installation of a reducing gear wheel of the transfer case
      Replacement of side epiploons of differentials
      Replacement of epiploons of the leading gear wheels of differentials
      Removal and installation of differentials
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal and installation of a reducing gear wheel of the transfer case

Details of installation of reduktorny assembly of the transfer case

1 — Reduktornaya assembly
2 — the Persistent washer

Arrow — the Lock ring


 PERFORMANCE ORDER

  1. Details of installation of a reducing gear wheel of the transfer case are shown on an illustration to which all references which are found in the text belong.
  2. Remove the mechanism of switching of the transfer case (see the Section Removal and installation of the mechanism of switching of the transfer case).
  3. Develop a reducing gear wheel (1) so that access to a lock ring (shooter) opened.
  4. Unclench a lock ring and at the same time from below push an entrance shaft up, - take and remove to the reliable place a persistent washer (2).
  5. Having pulled up, take a reducing gear wheel (1).
  6. Carefully wash out all components, wipe with suede and dry compressed air.
  7. Installation is made upside-down.
  8. In conclusion check the transfer case for existence of signs of development of leaks.