Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
- Transmission line
   + Coupling
   + Driveshafts
   + Power shafts
   - Transfer case and differentials
      Removal and installation of the module of management of the transfer case
      Removal and installation of the transfer case
      Replacement of an epiploon of an entrance shaft of the transfer case
      Replacement of an epiploon of an output flange of the back driveshaft
      Replacement of an epiploon of a forward output shaft
      Removal and installation of the servomotor of switching of the modes of the transfer case
      Removal and installation of the chain drive of the transfer case
      Removal and installation of a forward output shaft of the transfer case
      Removal and installation of assembly of a planetary reducer of interaxal differential of the transfer case
      Removal and installation of assembly of bearing assembly of the transfer case
      Removal and installation of the oil pump of the transfer case
      Removal and installation of the mechanism of switching of the transfer case
      Removal and installation of a reducing gear wheel of the transfer case
      Replacement of side epiploons of differentials
      Replacement of epiploons of the leading gear wheels of differentials
      Removal and installation of differentials
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Replacement of an epiploon of an output flange of the back driveshaft

Replacement of an epiploon of an output flange of the back driveshaft

1 — the Transfer case
2 — the Epiploon
3 — the Output flange of the back driveshaft

4 — the Sealing ring
5 — the Washer
6 — the Fullered nut


 PERFORMANCE ORDER

  1. Illustrative material on replacement of an epiploon of an entrance shaft of the transfer case is presented on an illustration to which all references which are found in the text belong.
  2. Remove the back driveshaft.
  3. Raschekante both release a fixing nut (6) and release a back output flange (3) from the transfer case (1), - try not to lose a washer (5) and a sealing ring (4).

The nut is subject to replacement without fail!

  1. Take a back epiploon (2) and by means of a suitable mandrel put new on its place.
  2. Establish into place an output flange, - in case of need replace a sealing ring (4). Tighten and fuller the NEW fixing nut.
  3. Connect the driveshaft.
  4. In conclusion check oil level in the transfer case, in case of need make the corresponding adjustment.
  5. Start the engine and check the transfer case for existence of signs of development of leaks.