- Details of installation of the oil pump of the transfer case are shown on an illustration to which all references which are found in the text belong.
- Remove bearing assembly (see the Section Removal and installation of assembly of bearing assembly of the transfer case).
- Remove a persistent washer (1).
- Remove a magnet (2).
- Take the filter (3) from a landing niche.
- Turn out fixing bolts and take from a case of the transfer case pump assembly (4).
- Carefully wash out all components, wipe with suede and dry compressed air.
- Installation is made upside-down, - track that the ledge of the bearing plate of the pump assembly developed by heads of bolts up was combined with lysky in bulk, - in case of need several times turn the last, - pump assembly has to sit down on a power shaft completely.
- In conclusion check the transfer case for existence of signs of development of leaks.
|
|