Mercedes M-Class W163

since 1997 release

Repair and operation of the car


Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
- Engine
   Check of compression pressure in cylinders
   Check of the engine by means of the vacuum gage
   Replacement of a belt of the drive of auxiliary units and elements of the mechanism of its tension
   + Petrol models
   - Diesel models
      Removal and installation of the engine
      Removal and installation of covers of the GRM drive
      Replacement of a gas-distributing chain
      Removal and installation of components of the GRM drive
      Installation of basic position of camshafts
      Verification of the basic provision of a balancing shaft (only series 628 engines)
      Removal and installation of the GRM components
      Removal and installation of a head(s) of cylinders
      Removal and installation of an electric motor of shutdown of inlet port (series 612 engine)
      Removal and installation of a final collector
      Replacement of a forward epiploon of a bent shaft
      Removal and installation of a back face cover, replacement of a back epiploon of a bent shaft
      Removal and installation of a damper of tortional fluctuations / pulley of a driving belt
      Removal and installation of a flywheel / driving disk
      Removal and installation of support of a suspension bracket of the power unit
      Service of the lubrication system
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal and installation of a flywheel / driving disk

M612

The order of implementation of the procedure is similar described above for the series 111 engine (see the Section Removal and installation of a flywheel / a driving disk).

M628

Details of installation of a driving disk on the series 628 engine

1 — the Driving disk
3 — the Washer
4 — the Directing pin

5 — the Bent shaft
6 — the Lock


 PERFORMANCE ORDER

  1. Details of installation of a driving disk on the engine of a series 628 are shown on an illustration to which all references which are found in the text belong.
  2. The order of implementation of the procedure is similar described above for engines of series 112 and 113 (see the Section Removal and installation of a flywheel / a driving disk).